springfield armory model 1898 serial number lookup

Serial numbers after this have noticeably less steel cut away in the bolt raceways after of the cartridge clip guide.

002884 Receiver heel rear end wall centerline thickness is 5/16 “.

002877 Highest documented serial number (complete rifle) shipped from Springfield Armory, Inc.

002709 Lowest known serial number (stripped receiver) sold by SA, Inc.

002068 Receiver left side connector lock hole reappears for good.

002010 Receiver left side connector lock hole is still missing.

becomes the casting supplier of M1A receivers.

The rear end of the M1A receiver bolt right lug slot, located under the rear sight base cover, was extended 0.080 ' to the rear to prevent possible damage to the bolt roller. 000567 to 000708 Within this serial number range, Valley Ordnance Co.000440 Lowest observed serial number with 7.62-mm marking on the receiver heel.000377 Highest observed serial number with 7.62-MM marking on the receiver heel.Receiver heel rear end wall centerline thickness is ¼ “. 000049 Receiver left side connector lock hole is missing.000011 Receiver left side connector lock hole is present.For example, the magazine well on M1A receivers was cut and broached by machine tool after Mr. As Melvin Smith moved to semi-retirement the receiver surfaces noted above were finished by machine. Note that the hand polishing served to enhance the aesthetic appearance but did not add to the functional ability of the M1A receiver. This cosmetic detailing is evident as late as M1A serial number 062857 but was no longer being done by serial number 064922. Specifically, these areas were: 1) the exterior heel corners on the sides 2) the flat surface aft of the operating rod channel 3) the top surface of the left receiver wall from the cartridge clip guide to the barrel ring 4) the vertical surface on the right side behind the cartridge clip guide all the way back including the windage knob ear 5) the left side of the barrel ring forward of the horizontal scope mount groove 6) the magazine well aft of the feed lips and 7) the top surface of the barrel ring after all machining operations that located off the barrel ring had been done.

were given a lot of hand grinding and polishing by Melvin Smith. 000001 to 063XXX Receivers machined by Valley Ordnance Co.An additional 120 rifles were built for Elmer Ballance by Glenn Nelson and Wayne Young before June 1974 using stripped or barreled receivers supplied by Elmer. in Texas assembled about 2000 complete rifles using USGI parts before it was sold to Bob Reese (Geneseo, IL). 000001 to 003700 Texas era receivers tend to exhibit one or more dimensional flaws as identified by retired M14 gunsmith Art Luppino.Lee Emerson has made the following M1A Serial Number Comments :

Springfield armory model 1898 serial number lookup